TECO UA1610, Руководство по обслуживанию

Страница: 90 / 388

D-47
5-3. Procedure for Upgrading the FAX Firmware
(Upgrading Procedure Using Telephone Line from fax
machine to fax machine)
NOTE
• The firmware transmitter fax machine must be loaded with the latest version of the firm-
ware. If the firmware is not upgraded, do that by following the “Procedure for Updating
the Firmware” described in the previous section.
1. Set the REMOTE MONITOR to “FULL” in ADMIN.MANEGEMENT mode of Utility.
(Firmware receiver fax machine)
☞
S-32
2. Set the firmware transmitter fax machine into the Service mode.
Utility, Stop, 0, 0, Stop, 0, 1
3. Select “5. FUNCTION” and then select “UPLOAD FIRMWARE”.
☞
S-95
4. Type the telephone number, to which the firmware receiver fax machine is connected.
(The relevant one touch dial number may be used if the telephone number has been
previously programmed in it.)
5. Press the Start key. This starts transfer of the data.
The Message Panel of the transmitter fax machine displays the same screen as that
appearing during ordinary faxing.
When the data transfer is completed, the ordinary standby screen reappears on the
Message Panel.
6. The firmware receiver fax machine receives the firmware data.
The following message appears on the Message Panel, indicating that transfer of firm-
ware data is started.
NOTE
• Do not use any of the printer and copier functions until upgrading of firmware is com-
pleted.
Data transfer started
Data transfer completed
Approx. 15 min.
4980D514AA
Firmware being uploaded
Field_Service_E.book 47 ページ ２００４年２月２５日 水曜日 午後６時５９分