TECO UA1610, Руководство по обслуживанию

Страница: 245 / 388

S-150
(21) SOFT SWITCH: #21
• Bit 1-2: T1 indicates the calling time after dialing, can adjust the T1 time longer by
changing the default value. The default T1 timer depends on each country regu-
lation.
• Bit 3: Some old machines can not accept DIS command over 4 bytes, and every time will
become fail. In this case you can set this bit to 1. If this bit is set to 1, JBIG and V8
capability will be disabled automatically.
• Bit 6-7: A fax to be received is canceled and the machine becomes unable to receive it if
the setting of “No. of RINGS” is made longer than the setting of “CNG duration
after dialing.” Be sure to make the “No. of RINGS” setting to a value shorter than
the “CNG duration after dialing” setting.
☞
S-40 Utility Mode/ RX operation/ No. of RINGS
• Bit 8: Sender machine’ s name will show on the other party’ s LCD or print on the report
if remote side is the same model.
Bit
No.
Designation Function
Initial
Setting
Bit HEX
8
NSS signal before
DCS
0: Not to send NSS signal if remote side is same
model
1: Send NSS signal if remote side is same
model
1
C
7
CNG duration
after dialing(T1)
1
6 0
5 T4 timer
0: 3.0 sec – Normal case
1: 4.5 sec
0
4 Reserved Reserved 0
0
3 DIS signal length
0: Normal length (bit 1 to 64)
1: 4 bytes DIS command – bit 1 to 32 only
0
2
Increase default
T1 timing during
calling
0
1 0
Duration 40 sec 60 sec 70 sec 120 sec
Bit 7 0 0 1 1
Bit 6 0 1 0 1
Descr
iption
T1 sec T1+ 30 sec T1+ 40 sec T1+60 sec
Bit 7 0 0 1 1
Bit 6 0 1 0 1
Field_Service_E.book 150 ページ ２００４年２月２５日 水曜日 午後６時５９分