TECO 320, Инструкция по эксплуатации

Страница: 62 / 156

62 EN - Operator’s manual
t
rouble
: p
ossible Causes
: s
olution
:
The lift does not raise
The motor direction of rota
-
tion is not correct
Interchange the two phases
on the main switch.
The oil in the hydraulic unit
is not sufficient
Add some hydraulic oil.
The pneumatic down valve
does not close
Check and clean if dirty.
Replace if faulty.
The suction pump filter is
dirty
Check and clean if needed.
The lifting capacity is not
sufficient
The pump is faulty
Check the pump and re
-
place, if needed.
Oil leakages in hydraulic
circuit
Check the circuit for any
leakage.
The lift does not lower when
the DOWN button is pressed
(without load)
the pneumatic down valve
is defective.
Contact support.
The down button is defec
-
tive
Contact support.
Oil leaks from the hydrau
-
lic circuit, the parachute
valves intervened.
Contact support.
Platforms do not stop in
standing position
Oil leaks in at least one
hydraulic pipe
Contact support.
Presence of impurities in
the pneumatic down valve
descent
Contact support.
At least one hydraulic cyl
-
inder is defective.
Contact support.
The lift does not lower
smoothly
Air in the hydraulic system Bleed the hydraulic system.
CHAPTER 11 - LAy-OffS / SCRAPPING
If the lift is to be out of use for a long period, disconnect the energy supplies, empty the
tank(s) containing operating liquids and protect any parts which might be damaged by dust.
If the lift is to be decommissioned, it must be made unusable by removing the control
unit components (the hydraulic pump and electric motor) from the control unit.
All parts which might be sources of danger must be rendered harmless.
Assess the lift’s category in relation to waste disposal.
Scrap as metal or electronic waste, consigning the various parts of the lift to the appropri
-
ate collection centres. If the lift is classified as special waste, dismantle it and subdivide
its parts by type, then dispose of them as required by law.