PAGE 3
User Manual
- Ecomatic 2010
User Manual
- Ecomatic 2010
In the diagnostic or calibration mode,
it is the
ENTER pushbutton (menu confirmation).
8.
BLAST ILLUMINATED
PUSHBUTTON
With spreading mode running (“Spread On”
light on), the pushbutton allows to force
maximum material spreading as long as the
pushbutton is held down.
9.
SPREADING FUNCTION
START/STOP ILLUMINATED
PUSHBUTTON
If the material spreading isn’t activated, push
the pushbutton to activate it and vice-versa.
Spreading mode activation is indicated by
the “Spread On” green led light.
10.
MATERIAL AMOUNT
SETTINGS POTENTIOMETER
After a minimum spreading width is set, the
potentiometer sets the material spreading
amount from a minimum to a maximum,
by acting on the proportional valve which
controls the rotation speed of the screw
conveyor engine.
11.
LIQUID AMOUNT
SETTINGS POTENTIOMETER
After a minimum spreading width is set, the
potentiometer sets the material spreading
amount from a minimum to a maximum,
by acting on the proportional valve which
controls the rotation speed of the engine
water pump engine.
12.
AMPSEAL MALE
CONNECTOR 35 POLES
It connects the control box to the shunt box
containing the relays and cables directed to
wards the system users.
13.
SPREADING WIDTH
SETTINGS POTENTIOMETER
It sets the spreading width from a minimum
to a maximum, by acting on the proportional
valve which controls the spinner engine.
14.
MENU ILLUMINATED
PUSHBUTTON
Illuminated pushbutton which allows to enter
the diagnostic or calibration mode menu.
15.
BACKLIT DISPLAY
It shows the current operating modes and
parameters.
16.
ILLUMINATED PUSHBUTTON
FOR RIGHT TAIL SHIFTING
(2° FU)
Operate the DC motor for right tail shifting.
In the diagnostic or calibration mode,
it is the
PLUS pushbutton (to increment a value).
17.
ILLUMINATED PUSHBUTTON
FOR LEFT TAIL SHIFTING
(2° FUNCTION –)
Operate the DC motor for left tail shifting.
In the diagnostic or calibration mode,
it is the
MINUS pushbutton (to decrement a value).
18.
“SPREAD ON” GREEN LIGHT
If on, indicates spreading mode activated. It
blinks if the vehicle speed is under 5km/h,
thus spreading mode is not active.
19.
“SPREADER ALARM”
RED LIGHT
If spreading mode is activated, the indicator
lights up in case of material exhaustion. If
spreading mode is activated, the indicator
blinks in case of low water. In case of low
water the water pump is switched off.
20.
SPINNER RAISED
RED WARNING LIGHT
It lights up if the spinner slants compared
to the operating position. In such cases, the
buzzer also emits three acoustic signals.
Whenever this warning light is up, the
material spreading is stopped and the
relevant “Spread On” turns off. In order
to reset the spreading mode, the spinner
must be lowered to its normal operating
position, then the spreading mode activation
pushbutton must be pushed a new.
