Tecnimoem Powerlift Up 2, Руководство пользователя

Страница: 18 / 24

ENGLISH
18
Finally, we add the platform feet
The electric actuator is not supplied and assembled on the hoist in the factory. If you need to assemble
the actuator, loosen the ring (18) and the mast (17). To disassemble do the opposite operation.
Connect FIRMLY in the base charge the remote control and the linear actuator .
4.- OPERATING INSTRUCTIONS
4.1.- Operating
To spread the legs, step on the left pedal. To narrow the legs, step on the right pedal. While transferring
patients and to negotiate doors and confined corridors, the legs should preferably be narrowed.
Lifting and lowering the patient is achieved by the electric actuator’s action on the hoist boom. These
movements are easy to control using the two buttons (up and down) provided on the hand control.
When the boom reaches the upper or lower limit of its run, it stops automatically.
When lifting or lowering a patient, it is recommended to press and hold the relevant button.
Repeatedly pressing and releasing the buttons will cause the actuator motor to start and stop each
time, using more battery and shortening its operating lifetime.
The electrical system includes a emergency stop red button. When the red button is in the out position,
the battery will operate normally. When the red button is depressed, the power from the battery is
cut off. To reset the button to the out position, turn it clockwise and release.
The knee´s support is adjustable: allowing five different heights from floor.
This support is basculable to guarantee the best support for knees adapting to each patient.
It has a strap with safety lock in case it is necessary to adjust the legs of the patient
4.2.- Recharging battery
System has a noisy system when the battery is near to finish, with this is possible made complete cycles.
If you only have one removable battery and one charging base, place the hoist near an electric socket,
connect the power supply cable to the charging base and plug into the mains (110-220V
While the battery is charging the actuator fails, the emergency stop should not be pressed and green
LEDs “on” lights. The battery indicator lines flash. When fully charged the 4 battery indicator lines will
remain fixed The green light “on” will remain on until you disconnect from the net-work.
If the hoist is used daily, it is recommended to recharge the battery during the night. The charger
will not allow the battery to overcharge.