Technogym Step 500i, Руководство по техническому обслуживанию

Страница: 56 / 182

STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 5.2
5.3. INSTALLATION
To correctly install the machine, proceed as follows:
1.
Ensure that the specifications and requirements for installation have been met (see paragraph
5.1. “Specifications and requirements”).
2. Position the machine as specified above, on a level surface that is free of vibrations and has
sufficient carrying capacity for the combined weight of the machine and user.
3. The machine is shipped fully assembled and packed in a carton fixed to a wooden pallet.
Only for 500i, 700i and 700i E models.
4.
Connect the mains lead to the power inlet socket on the machine.
5. Place the on/off switch in the 0 position.
6. Plug the mains lead into the wall outlet.
Only for 700i E model.
7.
Connect the antenna cable to the socket.
5.4. FIRST POWER-ON
After completing the installation procedure, the machine is ready for use.
On the 500i, 700i and 700i E models, simply turn the on/off switch from position 0 to position 1,
while on the 500i SP and 700i SP models it is necessary to get on the machine and start pedaling.
On power-up the machine performs a self-test of the upper and lower assemblies. After completing
the self-test, the machine enters the stand by state, awaiting a command from the keyboard.
To check the correct operation of the machine:
•
get on the machine;
•
start exercising;
•
check that the displayed speed varies accordingly;
•
check that exercise resistance varies when the “+” and “-“ effort level keys are pressed, or the
touch sensors on the 700i, 700i SP and 700i E models are pressed, and the effort level change
from 1 to 25;
•
put on the heart rate meter and check that the machine correctly reads the heart rate value;
•
only for 700i, 700i SP and 700i E: grasp the sensors and check that the machine correctly reads
the heart rate value.
•
only for 700i E: Carry out the procedure described in paragraph 9.7. “ Touch screen calibration”.