Technogym Step 500i, Руководство по техническому обслуживанию

Страница: 62 / 182

STEP EXCITE: Service & maintenance manual - rev. 1.4
Page 6.6
A
Are the DC v oltages at the
output of the brake board
correct?
3
NO
Are the DC v oltages at the
input to the display board
correct?
Replace the display
board and/or the 386
board
Replace cable STP-03
NO
YES
YES
4
Replace the brake
board
Does the mains v oltage
reach the input to the
brake board?
NO
YES
2
Replace cable STP-00
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
To speed up the troubleshooting procedure, check the state of the power indicator LEDs
on the various circuit boards.
(1) Slightly lift up the fastons on the machine power entry module. Place the tester probes across
the live and neutral pins on the same connector. The measured value should be approximately
220 VAC or 110 VAC depending on the mains voltage.
(2) As for step (1) but across pins 3 and 1 of connector CN3 on the Brake board.
(3) Using a tester, check that all the output voltages on connector CN1 of the brake board are
correct, referring to paragraph 2.8. “Wiring”.
(4) As for step (3) but on connector CN1 of the display board.