TechniSat MultyMedia TS 1, Руководство по эксплуатации

Страница: 14 / 91

Antenna configuration (DVB-S)
If in your selection of signal sources you have selected Yes
for DVB-S signals, this installation step will allow you to
adjust the configuration of your digital receiver to that of your
satellite antenna.
If you have selected
No for DVB-S, continue with the Point
Antenna confuguration (DVB-T) .
> If you wish to accept the standard antenna setting,
press the
green function key Accept . (Fig. 5-4)
Fahren Sie in diesem Fall mit dem Punkt Antennen-
Konfiguration (DVB-T) fort.
> If the configuration of your reception equipment does
not conform to the standard setting, press the
yellow
function key Change .
Multytenne
> If the digital receiver is being operated in conjunction
with a Multytenne antenna, use the
arrow keys
left/right to select on .
The switcvhing positions will be automatically adjusted
for the Multytenne.
In this case, continue with the point
Accept antenna
configuration (DVB-S) .
DiSEqC
> If you are using DiSEqC components in your receiving
equipment, use the
arrow keys up/down to mark
the line DiSEqC and use the arrow keys
left/right to select on .
(Fig. 5-5) . (Additional information on DiSEqC can be
found in Chapter 10, Technical terms).
> Then use the arrow keys in the column Satellite
to mark the switching position you would like to alloca-
te to a different satellite.
> Press OK to open the satellite list.
Position A/Option A
> Use the arrow keys up/down to mark the satellite
you are receiving with the DiSEqC setting Position
A /Option A , and confirm by pressing OK . (Fig. 5-6)
14
(Fig. 5-4)
(Fig. 5-5)
(Fig. 5-6)
BED_AN_Multymedia_TS1 2Q4eng 29.03.2006 10:41 Uhr Seite 14