8.6 System configuration
> Switch the Update software function to
On
by pressing
OK
.
>
In the line
Update time
use the
numeric keys
to enter the time at which the
software update is to be carried out.
>
To start the update of the operating software manually, press the
red
function key
Test
.
> Press the
Menu
key to return to normal operation.
Should the parameters of the data channel for downloading the soft- ware updates have
changed, you can correct these manually in this menu (manual programme scan).Current
transponder data can be obtained from your specialist retailer. In general you should not make
any changes in this menu.
Note:
The new software can be downloaded automatically only when the digital
receiver is in stand-by mode
.
The downloading procedure is indicated by the
display “SAtL” resp. “SAt0” to “SAt9”. Do not interrupt this procedure by
switching the receiver on or off.
Independently of whether you have switched the automatic software updating function on or off,
the system will automatically check for the availability of a new operating software version for
your digital receiver each time you switch on the receiver. If a new version is available, a
corresponding message will be displayed on screen. To start the software update, follow the
instructions displayed on screen.
Use this menu item to view the specific receiver data (e.g. current software version).
> Use the
arrow keys up/down
to mark this line in the sub-menu
Settings
.
> Confirm by pressing
OK
.
> Press the
Menu
key to return to normal operation
8.7 Condition access
This menu point takes you to the sub-menues for the CONAX /cryptworks Smartcard used, and
for the CI module. You can view information related to the Smartcard or the CI module used by
selecting the Smartcard or the CI interface, by pressing the
arrow keys,
then confirm by
pressing
OK
.
Manual Initialisation of the CI module
> You can initialise the CI module manually by pressing the
green
function key
CI
Reset
.
43
Содержание DIGIT MF4-S
Страница 52: ...Notes 52...
