TechniSat DIGIT MF4-S, Руководство по эксплуатации

Страница: 29 / 53

7.16.1 Manual programming of timers
7.15.8 Terminating SFI
> Press either the Menu or the TV/Radio key to return to normal operation.
7.16 Timer recordings
Your receiver is equipped with video recorder timers as well as with programme switching
timers. In terms of their programming, these timers differ only in that the relevant type of
timer is specified.
You may programme the timers manually as described in this chapter or by means of the
SFI function as described in Point 7.15.7.2.
1. Video recorder timer
When you use a video recorder timer, your digital receiver will be switched on resp. off for
the programme selected, so that it may be recorder, e.g. on a video recorder, in your
absence. Please note that you must programme your video recorder appropriately to
record the programme.
If the receiver was switched on by a video recorder timer, this will be indicated by the
message “rEc” in the display. In this mode, most of the functions of the remote control are
disabled, to avoid an accidental interruption of the recording. In stand-by mode, an active
timer will be indicated by a blinking of the colon in the time display resp. in the LED.
2. Programme change time
If your receiver is in normal operating mode, it will switch to the programmed programme
slot at the time selected. In contrast to the set- ting for a video recorder timer, the controls
remain fully functional, and the receiver will not be switched off at the end of the
programme.
> Press the
Menu
key to display the
Main Menu
.
> Use the arrow keys up/down to mark the item Time organiser .
> Confirm by pressing OK . The sub-menu Timer Overview will be displayed.
> Use the arrow keys up/down to select the type of timer you wish to
programme.
> Press the OK key to go to the entry window in order to programme a new timer
event.
To programme an event, proceed as follows:
Source
> Use the arrow keys to mark the column Source .
> Confirm by pressing OK .
> In the selection window that will now be displayed, use the arrow keys
up/down to select the desired source ( TV or Radio ).
> Confirm by pressing
OK
.
Depending on the previous setting, either the TV or the radio programme list will
now be displayed.
29