4.1 External installation
4.3 Video cassette recorder (VCR)
4.4.1 Analogue
4.5 Serial interface (RS 232)
4 Connections
The references mentioned below, i.e.
a b c
etc. refer to the illustration on page 10.
a
Use a suitable co-axial cable to connect the
LNB input
of the digital receiver with the
LNB of your external installation. Please also note Point 6 "Settings".
4.2 Connection to a television set
b
Use a SCART cable to connect the receiver (
SCART socket TV
) with the television set
(SCART socket). If your television set is appropriately equipped, it will switch automatically to
AV, and thus to satellite reception, when the digital receiver is switched on.
c
Connect the video recorder to the SCART socket marked
VCR
. In Playback mode, the
video recorder will supply a switching signal to the digital receiver, thus supplying the video
recorder signal automatically to the television set.
If your video recorder does not supply a switching signal, use the
0/AV
key to switch your
digital receiver to the external input
AV
. Pressing this key again will return you to normal
viewing operation.
4.4 Hi-Fi amplifier
d
To achieve the best possible sound quality, you may connect the digital receiver to a Hi-Fi
amplifier. Use a suitable cable to connect the cinch sockets
Audio R
and
Audio L
of the
digital receiver with an input of your Hi-Fi amplifier (e.g. CD or AUX - note that the Phono input
is not suitable).
4.4.2 Digital
d
If your amplifier is equipped with a suitable electrical or optical input, connect the socket
AUDIO OUT DIGITAL electrical
resp.
AUDIO OUT DIGITAL optical
with the
electrical resp. optical input of your amplifier.
Depending on the station selected, sampling rates of 32,
44.1 and 48 kHz are available.
In addition, if broadcast, the Dolby Digital signal (AC3) is available at this output.
The RS 232 interface is used for operating system updates as well as for pre-programming via
a personal computer PC.
4.6 Mains power connection
The digital receiver should only be connected to the mains power supply once the unit
has been completely connected to all other components in the system. This helps to
avoid damage to the digital receiver or other components.
> When you have made all the connections, use the mains power cable supplied to
connect the receiver with the mains power socket (230 V/50-60 Hz).
10
Содержание DIGIT MF4-S
Страница 52: ...Notes 52...
