8
Phone: (800) 597-3921 or (317) 803-8000 • Fax: (317) 803-8001
EXTRACTING YOUR CUTTING TOOL
• The cooling cycle automatically begins 5 seconds after the heating
cycle ends. The cooling cycle automatically stops after 3 minutes.
• You can manually stop the cooling cycle after 30 seconds by
touching the “Head Air Off” button.
• Touch the“Head Air On” buttons to restart.
COOLING CYCLE (00600 SHRINKPRO)
• Touch the “Quench Start” button to begin the 30 second cooling
cycle. The hot tool will be automatically lowered into the coolant
tank, the Head Air will automatically begin cooling the head.
• As the toolholder returns to the start position, high-pressure air
nozzles will remove excess moisture.
• Raise the induction head out of the way to make room to remove
the cutting tool.
COOLING CYCLE (00500 QUENCHER)
Note: Always wear the insulated glove when
handling tools, even after the cooling cycle has
completed.
Note: Toolholders for smaller cutting tools
require less power to heat, but must be heated
to a higher temperature than larger tools to
perform insertion and extraction.
• Toolholders must be at room temperature before attempting
to extract the cutting tool. Place the toolholder / cutting tool
assembly into the seat and secure the stop ring into the induction
head. Lower the head until there is an 1/8” gap between the stop
ring and the end of the toolholder.
• From the main screen, select your tool shank size.
• Begin heating procedure: Wearing the insulated glove on one
hand, with the other hand, press and hold the red “Start” button
located on the induction head. Continue holding the “Start” button
throughout the heating cycle.
• Approximately 2-3 seconds before the heating cycle ends, attempt
to remove the tool from the toolholder with the gloved hand.
• The heating cycle will stop automatically at the end of the set
duration.
OPERATIONS GUIDE
REMINDER:
If the tool cannot be extracted on the first try, cool the tool to
room temperature and increase the heating duration by 10% and try again.
Содержание 00500 ShrinkPRO Quencher
