Technicolor TG672, Руководство по установке и эксплуатации

Страница: 44 / 152

36
3 MANUAL INSTALLATION
E-DOC-CTC-20100728-0008 v2.0

mode
The automatic (default) or manual selection of the mobile operator and technology.

operator
This parameter can be used to fill in the Location Area Identifier. This code consists of a three-digit Mobile Country
Code (MCC) and a two-digit Mobile Network Code (MNC). For a list of all available Location Area Identifiers, please
refer to http://www.itu.int/dms_pub/itu-t/opb/sp/T-SP-E.212B-2010-PDF-E.pdf.

technology
The initial radio access technology (2G / 3G) to use for connection. If the selected technology is not available, the
alternative will be used.

initcommand
The AT command to be executed between SIM verification and the actual network connection. This command can be
used to perform vendor specific actions that are required for a successful connection.
Example:
To check all your mobile connection configurations, use the following command:
Step 4: Attach the mobile interface
Execute the following command:
With the following parameters:

intf
The name of the mobile USB interface.
Example:
It is advised to select manual mode and fill in the mobile operator and technology .
Your mobile interface can only be configured if it is not attached.
:mobile ifconfig intf=mobile_usb pin=1234 apn=web.provider.com operator=20610 technology=3G
mode=manual puk=12345678 initcommand=ATE
=> :mobile iflist
mobile_usb:
pin: ****
puk:
APN:
web.provider.com
mode: automatic
operator: 0
technology: 3G
init command:
=>
To check the configuration of a specific mobile connection use the command
mobile iflist intf=<your
intf>
.
:mobile ifattach intf=<string>
:mobile ifattach intf=mobile_usb
With the command
mobile ifdetach intf=<string>
you can detach a mobile USB interface.