Technicolor TG672, Руководство по установке и эксплуатации

Страница: 111 / 152

103
9 SHARING YOUR USB PRINTER
E-DOC-CTC-20100728-0008 v2.0
9.2 Configuring The Printer Sharing Service on Your
Technicolor Gateway
Proceed as follows:
1 Start a CLI session on the Technicolor Gateway.

For more information, see “4.3 The Command Line Interface (CLI)” on page 49 .
2 Define the LPD printer queues with the following command:
:printersharing LPD queue add name = <string>
[type = <{Feed|Raw}>]
[default = <{no|yes}>]
with:
 name:

Name of the queue. This name will also be used when configuring the computer.
 type:

This parameter represents the type of queue:

Raw : The Technicolor Gateway just passes through the data to the printer. In most practical situations, this is the
only queue type that will be needed.

Feed : The Technicolor Gateway passes through the data to the printer, but an extra page feed is sent after each
completed job. This type can be used when your printer is not ejecting the last page of a print job (for example
when using clients running Linux/UNIX). This queue type is to be used in exceptional situations only and may not
be properly supported by all printers.
 default:

When the parameter default is enabled, this queue will be used in case the user enters a wrong queue name. Only one
queue can be the default queue.
A typical configuration of printer queues on the Technicolor Gateway is shown below:
:printersharing LPD queue add name=myprinter type=Raw default=yes
:printersharing LPD queue add name=myprinteronunix type=Feed default=no
You can delete queues with the command
printersharing LPD queue delete name=<string>
.
Before deleting a queue, make sure printer sharing is disabled.
3 If you want to check the configuration of printer queues on the Technicolor Gateway, execute the following command:
=> :printersharing LPD queue list
LPD queue info:
name: myprinter
type: Raw
default: 1
LPD queue info:
name: myprinteronunix
type: Feed
default: 0
=>
4 Enable LPD printer sharing with the following command:
:printersharing LPD config [state = <{disabled|enabled}>]
With: