Techness RUN1000, Руководство пользователя

Страница: 21 / 89

2. APPLICATION OF LUBRIFICANT ON THE BELT:

Position the belt so that the seam is located in the middle of the plate.

Insert the spray valve in the spray head of the lubricant container.

Lift the belt at one side and hold the spray valve in a distance to the front end of
striding belt and plate. Start at the front end of the belt. Lead the spray valve in
direction of the back end. Repeat this process on the other side of the belt. Spray
each side for about 4 seconds.

Wait 1 minute to let the silicon spray spread, before starting the machine.
3. CLEANING:

Regular cleaning of the striding belt ensures a long product life.
Warning: The treadmill must be turned off to avoid electrical shocks. The power
cord must be pulled out of the socket, before starting the cleaning or maintenance.

After each training: Wipe the console and other surfaces with a clean soft and
damp cloth to remove sweat residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer,
keep any liquids away. Do not expose the computer to direct sunlight.

Weekly: To make the cleaning easier it is recommended to use a mat for the
treadmill. Shoes can leave dirt on the striding belt that can fall beneath the
treadmill. Clean the mat under the treadmill once a week.
4. BELT ADJUSTMENT:
You may need to adjust the running belt during the first few weeks of use. All
running belts are properly set at the factory. It may stretch of be off center after use.
Stretching is normal during the break-in period.
Adjusting the belt tension:
If the running belt feels as though it is ―slipping‖ or hesitating when you plant your
foot during a run, the tension on the running belt may have to be increased.
To increase the running belt tension:
A. Place 8mm wrench on the left belt tension bolt. Turn the wrench clockwise 1/4
turn to draw the rear roller and increase the belt tension.
B. Repeat STEP 1 for the right belt tension bolt. You must be sure to turn both bolts
the same number of turns, so the rear roller will stay square relative to the frame.
C. Repeat STEP 1 and STEP 2 until the slipping is eliminated.
D Be careful not to tighten the running belt tension too much as you can create
excessive pressure on the front and rear roller bearings. An excessively tightened
running belt may damage the roller bearings that would result in bearing noise from
the front and rear rollers.