ST – 480
III.b.1)Registration.
To register an additional valve enter the serial number of the control module of
the ST-61 mixing valve servo (look for the five-digit number on the cover of
this module). Without this number the valve cannot be activated.
III.b.2) Switch on
(setting as for the main valve - see Section
III.a.1).
III.b.3) Set-point valve temperature
(
setting as for the main valve
– see Section III.a.2)
III.b.4)Room thermostat
If the valve is to be operated with a room thermostat, you should
select its type:
module controller (traditional two-state type – “from the module”),
standard or TECH controller (traditional two-state type – “from the
controller”),
TECH algorithm controller (RS communication),
room temperature difference
(setting as for the main valve – see
Section III.a.11),
set-point change
(setting as for the main valve – see Section III.a.11).
III.b.5) Temperature control
(Setting as for the main valve – see
Section III.a.3).
III.b.6) Opening time
(Setting as for the main valve – see Section
III.a.4)
III.b.7) Single step
(Setting as for the main valve – see Section III.a.5).
III.b.8) Minimum opening
(
Setting as for the main valve – see Section
III.a.6).
III.b.9) Type of valve
(Setting as for the main valve – see Section
- 19 -
