TEC Infra-red Cherokee CH-10SS, Руководство пользователя

Страница: 11 / 22

9
General Overview
WARNING:
NEVER ATTEMPT TO USE THIS OR ANY
OTHER GAS APPLIANCE WHEN YOU SMELL GAS. DO
NOT LEAVE THIS APPLIANCE UNATTENDED. KEEP
CHILDREN AND PETS AWAY FROM THE APPLIANCE
AT ALL TIMES.
WARNING:
THIS APPLIANCE IS NOT INTENDED FOR
AND SHOULD NOT BE USED AS A HEATER. DO NOT
MOVE THIS APPLIANCE WHILE IN OPERATION.
ALLOW THE UNIT TO COOL BEFORE MOVING OR
STORING.
WARNING:
THE BURNER VENTURI TUBE SHOULD
BE INSPECTED FOR SPIDER WEBS AND OTHER
OBSTRUCTIONS PRIOR TO EACH USE (SEE FIGURE
11). IF ANYTHING IS FOUND, CLEAN THE TUBE
COMPLETELY. A CLOGGED TUBE CAN LEAD TO A
FIRE BENEATH THE UNIT.
CAUTION:
THE COVER MUST BE OPEN DURING
BURNER OPERATION AND THE HOOD/HEAT SHIELD
ASSEMBLY SHOULD BE IN PLACE AT ALL TIMES
DURING BURNER OPERATION.
NOTICE:
NEVER PLACE FOOD OVER A BURNER
THAT IS NOT IN OPERATION. FOOD DRIPPINGS
WILL NOT BE INCINERATED AND THE SMALL PORTS
MAY BECOME CLOGGED. THE BURNER SHOULD
NOT COME IN CONTACT WITH WATER OR OTHER
CLEANING FLUIDS. IT COULD DAMAGE THE
BURNER CAUSING IT TO FUNCTION IMPROPERLY.
NOTICE:
TEC RECOMMENDS THAT A FIRE
EXTINGUISHER FOR CLASS A, B, C AND D FIRES BE
READILY AVAILABLE AT ALL TIMES.
Burner Ignition
Procedure
Please read instructions before lighting.
1. Open cover.
2. Ensure gas supply cylinder Valve is closed. Ensure
Burner Output Knob is in the OFF position
(see Figure 6).
3. Open the Valve on the gas supply cylinder.
4. Depress and rotate Burner Output Knob to HIGH
setting.
5. Slowly rotate Rotary Spark Knob clockwise twice,
and check for burner flame.
6. If a flame is not present immediately, turn Burner
Output Knob to OFF position, leave the cover open,
and wait 5 minutes. Then repeat steps 3 through 6
until ignition occurs.
7. Rotate Burner Output Knob to desired cooking
level.
Burner Ignition Without Sparker
Procedure
Please read instructions before lighting.
1. Open cover.
2. If ignition does not immediately take place, turn
Burner Valve Knob to OFF and wait 5 minutes.
Then repeat the lighting procedure.
3. Insure all Valves are closed.
4. Open the Valve on the gas supply cylinder.
5. Place a match into the match wand provided. Ignite
the match. Using the match wand, place the lit
match approximately 1/4” above the burner screen.
6. Ensure the match is lit. If not, repeat step 5.
7. Depress and rotate the Burner Control Knob to ON.
Check for a burner flame. If a flame is not present,
turn the Burner Control Valve Knob to OFF, leave
the cover open, and wait 5 minutes. Then repeat the
lighting procedure.
Operation
*
OFF
FERME
BURNER LOW
BURNER
HIGH
Figure 6.
Burner Output Knob
Figure 7.
Burner Ignition Without Sparker