TEC Electronics FanControl-GSM, Руководство пользователя, Страница: 7 / 15

FanControl‑GSM v2
7
Red and blue LED indication can be found in table 3.
Table 3. GSM LED and GPRS LED indication
Red LED (GSM) Blue LED (GPRS)
ON GSM-network found GPRS connected
Constantly flashes Looking for GSM-network Connecting to GPRS
1 short infrerquent
flash
GSM in sleep mode –
GSM in sleep mode GPRS - connected
Vehicle identification
All vehicles compatible by the device are devided into special groups and subgroups. Each
vehicle has its own group and subgroup. Interfacing the module with a vehicle means programming
a vehicle group and subgroup. A group and subgroup can be easily programmed in TECprog or
using the programming button of the device.
Interfacing a vehicle manually by using the PB:
The CAN bus shouldn’t be connected before the vehicle identification is complete.
1. Connect the module to power, wait until the green LED starts flashing shortly .
2. Press the PB 4 times, the green LED will flash 4 times (will indicate the group/subgroup if it
was programmed) and will light up.
3. Enter a group number. Press the PB the number of times corresponding to the group number.
After a short pause (1.5 sec) the LED will indicate the entered group number.
4. Enter the subgroup number by pressing the PB the required number of times. After a short
pause (1.5 sec) the LED will indicate the entered subgroup number.
5. After a short pause (approximately 4 seconds) the green LED will indicate the entered group
and subgroup number.
If the group is a two digit number — enter the first digit, wait for indication, then enter the
second digit — wait for indication.
Make sure you entered the vehicle model correctly by counting the LED flashes (group — pause;
subgroup — pause).
• press the PB one time if everything is correct, the green LED will flash 4 times;
• press the PB 2 times if incorrect, The green LED will light up fro 15 sec. After that you can repeat
programming the vehicle group and subgroup.