Team HAM MobileCom 1011, Руководство пользователя

Страница: 23 / 42

FUNCTION KEYS
[MEM]
MEMORY CHANNELS M1-M6:
To enter or quit the memory channel mode , press the key
【
MEM
】
(1). The letter M (21) to
the right of the frequency or the memory channel number indicates the active status of the
memory channel mode.
In channel mode the display reads
ME--M ( 1 - 6 ). In frequency mode, the frequency of the se-
lected memory channel is displayed. Use the key
【
FRQ
】
(4) to switch between the channel
mode and the frequency mode. The selected frequency band (A-I) is shown on the top of the
LCD (13).
save a memory channel:
To save a channel as a memory channel, exit memory channel mode first.
Then, select the frequency and hold the key
【
MEM
】
until the memory channel mode is acti-
vated. The letter M and ME--M ( 1 - 6 ), with M ( 1 - 6 ) blinking, will appear.
Now, select the memory channel number where the frequency should be saved and hold the
key
【
MEM
】
until M ( 1 - 6 ) stops blinking.
[MODE]
To switch between the operating modes FM-AM-USB-LSB, press the control
【
MODE
】
(2).
The actual operating mode is shown in the upper left LCD (5).
[BAND]
To switch between the frequency bands A-B-C-D-E-F-G-H-I-J, press the control
【
BAND
】
(3).
The actual frequency band is shown in the upper left LCD (13).
[FRQ]
Use the control
【
FRQ
】
(4) to switch between frequency and channel mode.
[MENU]
All functions and settings of the HAM MobileCom 1011 are organized in three different
menus.
The menus
channel settings (PD, HICUT, NB, ECHO, +10kHz, ROGER, BUSY, SCAN) and
general settings (BEEP, INDIC, MIC, NOG, TOT, TSR, TDC, SCAN, FIN, COLOR, RESET)
are activated with the control [MENU] (5).
To open the menu channel settings , press the key
【
MENU
】
(5) shortly. The symbol F (1)
appears in the upper left corner of the LCD. Press the channel selector [ PUSH ] (14) to open
the menu.
To open the menu general settings , press the key
【
MENU
】
(5) approximately 2 seconds.
Once the menu is activated, use the rotary channel selector (14) to select a function.
To edit the setting for the selected function, press the channel selector [
PUSH ] (14).
Make your selection by turning the rotary channel selector and press it to confirm your selection.
To exit the menu press any key.
[SCAN]
channel scanning
1. Start channel scanning by pressing the key
【
SCAN
】
(6). The symbol SC (4), located in
the lower left corner, starts blinking.
2. Change the direction of the scanning (Up / Down) by turning the rotary channel selector.
3. To stop the channel scanning press the key
【
SCAN
】
(6) again.
23
HAM_MobileCom-1011_final_17-7-14:Layout 1 7/22/2014 10:21 AM Seite 23