Team HAM MobileCom 1011, Руководство пользователя

Страница: 18 / 42

SETUP
microphone holder
1. Mount the microphone holder with the two threading screws onto the desired location in the
vehicle.
2. Plug in the 6-pin micrphone connector into the front jack (16), located on the left side of
radio. Tighten the retaining screw of the microphone plug.
antenna
The antenna should be matched with the radio, otherwise a part of the transmit power will
be reflected in the antenna and will not be radiated. This will reduce the range of operation.
Since the antenna is one of the most important links in the setup, the following criterias are
very important.
General :
> The frequency range of the antenna has to cover the programmed frequencies on the radio.
> The positon of the antenna should be as elevated and unobstructed as possible.
> Ensure that the cable and the connector of the antenna are intact and that the plug is
connected properly.
> Ensure that the cable is not bend too much.
> The length of the antenna rod and the range of operation are related. The longer the rod,
the further the distance.
Upon antenna-mounting, the following has to be considered :
> The antenna should be placed in the middle of a vehicle part.
> The antenna base should have good contact to a metal, conductive surface of the vehicle.
Beside the fixed mounting of antennas, which requires drilling of the body, antennas can
be temporarily set up via a magnetic mount.
> To avoid interferences with radio and TV reception, place the antenna as far away as
possible from these sources of interferences.
> All connected cables should not exceed the maximum length of 3 meters.
For a good grounding of the antenna, we recommend one of these placements:
Base the decision about the position of the HAM MobileCom 1011 in your vehicle on the
aspect of safety. No part of the setup, i.e. radio, microphone, cable, etc., should restrict or
obstruct the driver or passenger in any way.
U-bracket holder
1. Mount the U-shaped bracket holder with the threading screws and the washers at the
desired location in the driver cabin.
2. Mount the radio onto the bracket holder with 2 adjusting screws and rubber pads in the
rear holes of the bracket holder.
3. Set the desired angle of the radio at the bracket holder and fix the angle with the remai-
ning adjusting screws and rubber pads.
18
HAM_MobileCom-1011_final_17-7-14:Layout 1 7/22/2014 10:20 AM Seite 18