24
CD Transport
Playback is not possible.
e
If the disc is upside down, reload it with the labeled side up.
e
If the disc is dirty, wipe it clean.
e
If a blank disc is loaded, replace it with a disc that has record-
ings on it.
e
Depending on the quality and recording conditions of the
disc, some CD-R/CD-RW discs cannot be played back.
e
This unit cannot play back unfinalized CD-R/CD-RW discs.
The sound skips.
e
Vibrations will cause the sound to skip. Install this unit in a
stable location.
e
If the disc is dirty, wipe it clean.
e
Do not use discs that are scratched or cracked.
Clock sync
The CLOCK indicator does not stop blinking.
e
Set clock synchronization to OFF when not using it.
e
A clock signal to which the unit cannot synchronize might be
being input. Check the connections of the clock sync connec-
tors and the settings of the connected devices.
Since this unit uses a microcontroller, external noise and other inter-
ference can cause the unit to malfunction. If this occurs, unplug the
power cord, wait for a while, and then turn the unit on again and
restart operations.
Note about condensation
If this unit is brought from a cold outdoor environment into a
warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur on
operating parts or lenses, resulting in improper operation. If this
occurs, leave the product on and wait one to two hours. This
should enable normal playback.
Troubleshooting (continued)
Restoring default settings
1
While pressing and holding the MENU button,
set the STANDBY/ON switch to ON.
2
Release the MENU button when the FACTORY
RESET menu appears.
MENU
FACTORY RESET
ARE YOU SURE?
3
Press the skip knob (
.
/
/
).
PLEASE WAIT!
The usual screen will appear after resetting completes.
Display example
NO DISC
ATTENTION
o
Do not put the unit in standby until the usual screen
appears.
o
This operation will restore all settings to their default values.
o
The factory default settings are the setting values shown in the
screen images used in the explanations of this manual.
