408-35042
Rev C
17
of 26
Figure 16
(8) If the feed pawl is at the rear edge of the feed hole before the slide hits the rear stop adjust
screw, turn the rear stop adjust screw clockwise until the screw meets the slide, as follows:
Figure 17
(a) Loosen the Rear Stop Locking Screw.
(b) Turn the Rear Stop Adjust Screw clockwise until it meets the slide.
(c) The Feed Pawl must be positioned to the rear edge of the feed hole.
(d) After verifying positions, tighten the locking screw.
(9) If the slide hits the rear stop adjust screw before the feed pawl is at the rear edge of the next
hole, the rear stop adjust screw needs to be adjusted. Adjust the rear stop adjust screw
counter-clockwise until the feed pawl is at the rear edge of the feed hole.
(a) Loosen the Rear Stop Locking Screw.
(b) Turn the Rear Stop Adjust Screw counter-clockwise.
(c) Push the slide against the rear stop adjust screw.
(d) The Feed Pawl must be positioned to the rear edge of the feed hole. Repeat steps (b) and
(c) until the feed pawl is at the rear edge of the feed hole.
(e) After verifying positions, tighten the locking screw.
(10) Extend the slide manually, then retract the slide. Check to ensure the feed finger is in the
middle of the feed hole. If it
isn’t
, repeat steps (7) and (8) to adjust the rear stop position of the
feed finger.
(11) Apply pressurized air to the air feed module.
(12) Cycle the terminator in jog mode or manually until the feed pawl retracts.
(13) Verify the pawl is in the correct location. If it is not in the correct position, repeat steps (7) thru
(12).
Feed Pawl to Rear of
Terminal Feed Hole
Clockwise
Rear Stop Adjust Screw
Rear Stop Locking Screw
