408-1610
11 of 11
Rev M
3. Check the clearance between the bottoming
surfaces of the crimping dies. If the clearance is
.025 mm [.001 in.] or less, the ratchet is satisfactory.
If clearance exceeds .025 mm [.001 in.], the ratchet
is out of adjustment, and must be repaired. Refer to
Section 8, REPLACEMENT AND REPAIR. If the
tool conforms to these inspection procedures,
lubricate it with a THIN coat of any good SAE‡ 20
motor oil and return it to service.
8. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 13. Parts other
than those listed in Figure 13 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your TE
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 1-717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
9. REVISION SUMMARY
Since the previous release of this sheet, the new
company logo was applied.
TOOL NUMBERS AND REPLACEMENT PART NUMBER
ITEM
DESCRIPTION
591 SHORT HANDLE
59250 LONG HANDLE
59275 SHORT HANDLE
59300 LONG HANDLE
69692-1
LONG HANDLE
69693-1
LONG HANDLE
QTY PER
ASSY
1
Support, Locator
---
---
59755-1
59755-2
1
2
Screw
---
---
1-21002-3
1-21002-3
2
Figure 13
Содержание 59275
Страница 2: ...408 1610 2 of 11 Rev M Figure 2 Cont d...
