TE Connectivity 2155369, Инструкция по эксплуатации

Страница: 4 / 26

Customer Manual
取扱 明書
409-78005
Rev B3 4 of 26
For Safe Operation
1. Keep work area clean

Cluttered areas and benches injuries
2. Bystanders

Make sure all bystanders are clear of the work area when handling, starting and operating tool
3. Store batteries or idle tools

When not in use, tools and batteries should be stored separately in a dry environment and out of
reach of children or keep under lock and key.

Ensure that battery terminals must not be shorted by other metal parts such as screws, nails, etc.

Store or carry tools and batteries between
–
10
℃
to 40
℃．
4. Stay within the capacity of the tool
 Do not exceed the capacity. And use the tool for manufacturer’s intended purpose only.
5. Use the right size tool

Do not use small tools or attachments to do heavier duty job. Do not use tool for purposes not
intended.
6. Dress properly

Do not wear loose clothing or jewelry, they can be caught in moving parts. Non-skid footwear and
rubber gloves are recommended when working outdoors. Wear safety cap to protect the head.
7. . Do not over-reach

Keep proper footing and balance at all times.
8. Stay alert

Stay alert with the work. Use common sense. Do not operate the tool when you are tired
9. Do not abuse the cord of the charger

Do not carry the charger by the cord. Do not yank the cord to disconnect from the outlet.

Keep the cord clear of heat, oil, and an accessible sharp point
10. Use the extension cord for outdoor use

Use cabtire type extension cord when charging outdoor
11. Maintain tools with care

Keep the tool clean for better and safer performance. Follow instructions for lubrication.

Inspect the charger cord periodically and if damaged have repaired by an authorized service
facility

Inspect the extension cord periodically and if damaged , replace with new one.

Always keep the grip of the tool clean and dry and free of oil and grease.
12. Check damaged parts

Do not operate the tool if it is damaged, improperly adjusted or not completely and correctly
assembled.

Check for alignment of moving parts, smooth running of moving parts, breakage of parts,
mounting and any other condition that may affect its operation. If damaged, it should be properly
repaired or replaced by an authorized service facility.

Have defective switches replaced by an authorized service facility. Do not use the tool if the
switch does turn it on and off.
13. Have your tool repaired by an authorized service center

This tool is constructed in accordance with the relevant safety requirements. Repairs should
only be carried out by a qualified person using original spare parts, otherwise this may result in
considerable danger to the user.