TE Connectivity 1804150-1, Руководство пользователя

Страница: 8 / 26

409-10064
8 of 26 Rev B
2.4. Machine Guards
(Figure 6)
A combination of guards is installed to provide protection for the operator while maintaining proper visibility of
the work area. The main guard swings open to the left and the hinged guard, swings open to the right to allow
easy access for applicator installation and set up. The right guards has a latch that must be pressed before the
door will open. A safety interlock for the guards prevents the machine from cycling if the guard doors are open
during production operation.
NOTE
i
If the DCC terminator control panel was on (indicated by a green light above the green Main Air On button) when the
guards were opened, the DCC terminator will turn off (indicated by a red light above the red Main Air Off button). This will
also turn off the main air and cause a guard open error light to flash. The error must be reset before the DCC unit can be
turned on.
Reel Support Bracket
Terminator Control Panel
(Shown With Batch Counter Kit)
Main Guard
DCC Terminator
Control Box and
Operator
Interface
Crimp
Quality Monitor
1320420-2
Hinged Door
Release
Gripper
Pressure
Regulator
Hinged Door
Figure 6
2.5. Description of Operation
A. Machine Cycle With a Good Crimp as Determined by the Crimp Quality Monitor:
1. The operator places stripped wire through the opening in the guard insert, through the open grip jaws and
against the wire stop of the applicator.
2. The operator presses the foot switch.
3. The grip jaws close on the wire.
4. The terminator cycles to apply a terminal to the wire.