TE Connectivity 1804150-1, Руководство пользователя

Страница: 23 / 26

NOTE
i
409-10064
23 of 26 Rev B
The gripper mechanism transferring to the right isn't as critical as the mechanism transferring to the left so the extend
switch location isn't as critical as the retract switch.
C. Chop Cylinder Retract Switch Adjustment
(Figure 14)
1. “Power up" the main air by turning the DCC terminator "on."
2. Turn "off" the main air.
3. Open the guards and look at the chop cylinder retract switch.
4. If the LED on the switch is not lit, adjust the switch.
5. Loosen the screw on the switch.
6. Slide the switch to the bottom of the cylinder.
7. Slide the switch up until the LED on the switch lights.
8. Slide the switch up an additional 3mm [.125 in].
9. Tighten the screw securing the switch.
Fixed Carrier Chop
Blade Screws
Scrap Guide
Chop Cylinder
Chop Cylinder
Retract Switch
Chop Cylinder
Extend Switch
Figure 14
D. Chop Cylinder Extend Switch Adjustment
(Figure 14)
1. “Power up" the main air by turning the DCC terminator "on."
2. Enter Step Mode and step through the DCC terminator cycle until the wire blades open and the chop
blades close.