8
05/2006
Opening and closing the case
1. Opening the case
The lower panel is attached to the alumin-
ium profile by two hexagon socket screws.
(1)
Unscrew both screws using an key for
hexagon socket screws only half way:
(2)
Turn the lower panel to the left, without
removing it completely.
(3)
Slide the name plate glass fully down.
2.
Feed the cables through the cable duct.
3.
Attach the device safely to the wall from
the attachment holes (see overview) using
suitable screws.
Take care not to pinch the cables under
the spacers on the device back.
4. Closing the case
Slide the name plate glass upwards under the front panel.
Turn the lower panel to the right until the recess fits over the screw.
Tighten the screws.
!
When sliding the name plate glass upwards take care not to damage the rubber seals
in the guide grooves.
When fitting additional devices make sure that you can slide the name plate glass of the
device downwards out of the profile. Do not fit a device below the device.
!
Never seal the device using silicon! Condensate must be allowed to drain and evapo-
rate.
Cable connection
General notes
!
Use the small screwdriver supplied to connect the lines and prevent damage to the
device.
Please note
•
the lines should not be run in front of the LED to prevent obstruction of the name-
plate illumination
•
the lines must not be squeezed below the spacers on the back of the front-station.
TCS TürControlSysteme AG
•
Geschwister-Scholl-Str. 7
•
39307 Genthin
Subject to change without notice.
Phone.: +49 39 33 / 87 99 10
•
Fax: +49 39 33 / 87 99 11
•
www.tcs-germany.com
PI_GB_VPES_VPDS_Art0016079_2v0.doc
mi
