10
05/2006
Video commissioning
!
First fully install the system, then connect power!
•
V1 and V2 must never - not even temporarily - be connected to the P, a or b wires.
Such a connection would destroy the device.
•
When connecting the video wires V1 (+) and V2 (-) the polarity must be observed.
If the image is distorted after commissioning, switch off the device and replace the
wires for the video signal.
Microphone and loudspeaker volume setup
!
For adjustments use the small screwdriver supplied!
Volume control
microphone
In-house
station
volume
adjustment
loudspeaker
Front-door station
volume
adjustment
The volumes have been set to an average value
at factory. A modification may not always be
necessary.
When adjusting please note:
The amplification of loudspeaker and microphone
cannot be set independently from each other.
Too great volume will cause a feedback effect
(whistling).
Nameplate labelling
The templates are available on our website
System and technology basics\ Product installa-
tion and use \ labelling of the nameplate
1.
Enter the desired name into the template.
2.
Print the name plate on the special film* and
cut it to size.
3.
Insert the cut plates from the side into the po-
ckets on the name plate glass.
*
We recommend to print the name plates on a durable special
film
.
The film can be ordered directly from TCS: Writable poly-
ester film for name plates DIN A4.
TCS TürControlSysteme AG
•
Geschwister-Scholl-Str. 7
•
39307 Genthin
Subject to change without notice.
Phone.: +49 39 33 / 87 99 10
•
Fax: +49 39 33 / 87 99 11
•
www.tcs-germany.com
PI_GB_VPES_VPDS_Art0016079_2v0.doc
mi
