07/2012
11
TCS TürControlSysteme AG
Subject to technical changes.
E-Mail: [email protected] www.tcsag.de
PI_ISH3130-uk.doc
1A
2-wire/3-wire operation
The jumper J1 is adjusted for 2-wire operation
in delivery state.
J1
2-wire operation (state of delivery)
Install the jumper J1 at both upper contacts
for 3-wire operation.
3-wire operation
Ring tone selection
For 4 different incoming calls (door calls from 2 different front-door stations, floor call and
internal call) different ring tones can be selected.
1
End voice communication. Press call Off button for 8 sec. Both LEDs are ON and
an acknowledgement tone sounds, the ring tone selection is activated.
By pressing the following buttons, a ring tone can be selected. You can choose be-
tween 13 tones.
2a
select door ring tone
of the front-door sta-
tion*
Press the
door release button
until the required ring tone
sounds. The ring tone selected last will be stored.
2b
select door ring tone
of the floor door
Press the
light switch button
until the required ring tone
sounds. The ring tone selected last will be stored.
2c
select internal ring to-
ne
Press the
control key
until the required ring tone sounds.
The ring tone selected last will be stored.
3
Shortly press the call OFF button.
Or: If no button is pressed for around 8 sec, the device ends the ring tone selection
automatically. Both LEDs go out and an acknowledgement tone sounds, the ring
tone selection is deactivated.
* The ring tone is identical for all front-door stations and can be selected only identically for all.
To select a second ring tone it is necessary to activate the call distinction by changing the audio AS limit.
Changing the audio AS limit is possible only with the configuration
software configo™.
Adjust volumes
Adjustable in 8 steps. A signal tone reproduces the adjusted volume when turning the ring
tone volume control. If the adjustment is finished, the adjusted ring tone sounds in the ad-
justed volume.