17
Repeat the programming of an already programmed bell button, always change only the second serial
number. If you want to change the serial number that was programmed first, you have to delete both
serial numbers and then reprogram both serial numbers.
1
Switching on the programming mode
power supply and control unit
Shortly press the RUN/PROG button.
The LED blinks.
The programming mode of the system is switched ON.
2a Programming via voice communication
or
Establish a voice communication
to the front-door station.
Press the bell button until after 6 s a
Prog2 sounds, keep the button pressed
and after another 6 s a NoProg-tone
sounds and ...
…a ring tone sounds at the front
door and indoor station.
1)
Release the bell
button.
2b alternatively: Programming via floor push button (if the indoor station is inaccessible)
Shortly press the floor push-button
twice in quick succession. Each a
ring tone sounds.
Press the bell button until after 6 s a
Prog2 sounds, keep the button
pressed and after another 6 s a
NoProg-tone sounds and ...
…a ring tone sounds at the front
door and indoor station.
1)
Release the bell
button.
Repeat the steps until you have programmed all bell buttons.
4 End
programming
mode
Shortly press the RUN/PROG button.
The LED is on.
The programming mode of the system is switched
OFF.
1)
If there sounds a Progsperr tone instead, at the front-door station a programming lock is set. You can deactivate the programming lock
only with the Service Device TCSK or the configuration software configo
TM
.
