16
Programming a bell button
1
Switching on the programming mode
power supply and control unit
Shortly press the RUN/PROG button.
The LED blinks.
The programming mode of the system is switched ON.
2a Programming via voice communication
or
Establish a voice communication to the
front-door station.
Shortly press the bell button at the
front door station.
A ring tone sounds at the front door and indoor
station.
2b alternatively: Programming via floor push-button
Shortly press the floor push-button twice in
quick succession. Each a ring tone sounds.
Shortly press the bell button at
the front door station.
A ring tone sounds at the front door and indoor
station.
1)
Repeat the steps until you have programmed all bell buttons.
4 End
programming
mode
Shortly press the RUN/PROG button.
The LED is on.
The programming mode of the system is
switched OFF.
1)
If there sounds a Progsperr tone instead, at the front-door station a programming lock is set. You can deactivate the programming lock
only with the Service Device TCSK or the configuration software configo
TM
.
Programming a second indoor station at the same bell button (parallel call)
If a parallel call is configured, 2 indoor stations are called with 1 bell button at the front door station. The floor push-
button only calls the firmly wired indoor station. If bell button and floor push button should have the same functional-
ity, the function parallel allocation is to be used. On this occasion several indoor stations respond to the same bell
button as well as to the same floor push button. The parallel allocation is to be configured with the Service Device
TCSK or the configuration software configo
TM
.
