Item
Description
Filter on source
port
Can be used to filter incoming signals. With multiple signals sent to the
same IP address and destination port number, Filter on source port can
be used to filter the input, i.e. to accept only signals from the transmitting
port specified here. The filter will not be active if set to 0 (the default and
recommended setting).
Connection
priority
Parameter intended for use with MX Software Development Kit.
Reorder buffer
size
Used to reorder incoming packets.
Stream fail
delay
Range: [0...10000] ms. Default: 300 ms. Timeout in ms before going to
NoStream state.
RTP control
mode
Select the transport protocol to control the stream.
None
No transport protocol selected.
FloodGuard
Flooding prevention mechanism. For
more information, see the note on
FloodGuard later in this chapter.
RTCP
Real-Time Control Protocol, a network
control protocol for use in
communications systems to control
streaming media servers.
RTP type (0 =
auto)
Default value: [0]. This parameter determines the RTP payload format
(e.g. H.264, MPEG-2/4, or audio). To avoid an RTP type conflict, the
values specified on both sides of the connection must be the same. The
default value of "0" automatically sets the appropriate media type. You
are advised not to change this setting.
Link loss alarm
timeout
Range: [1...1000] s. Default: 10 s. Time in seconds before alarm sent.
12.3.7
RTSP Transmitter
Audio > Advanced > RTSP Transmitter
Audio
105