TC Electronic Studio Konnekt 48, Руководство пользователя

Страница: 22 / 72

10 Speaker sets
The speaker sets can be labeled individually. Simply
click in the text field and enter a name of your choice.
Assigning an output to a speaker set
With no bass management an output is assigned
directly to a speaker set by checking the ASSIGN
check box for the output.
However, when bass management is used you must
set main speakers to “main” and sub to “sub”.
Example: Example:
Without Bass Management
With Bass Management
11 Trim
Range: -20 dB to 0 dB
Individual trim levels for each channel.
12 DLY
Range: 0 to 30 ms
Perfect listening conditions and placement of
speakers according to an ITU 775 circle are not
always possible. This delay parameter allows for
individual alignment of speakers.
13 Output label
The physical outputs have fixed names according to
the labels on the rear panel. However, you can also
add an additional personal label to these channel
outputs.
Bass management
The bass management system is designed to subtract the
bass contents of all main channels and reproduce this by
the use of a subwoofer and is easily set up with the
Studio Konnekt 48.
Let us take at look at the components and how to set up
bass management using the Studio Konnekt 48.
The Subwoofer
A subwoofer is a monitor that reproduces low frequencies.
The purpose is to take over from the main monitor(s) as
frequencies approach the lower end of the monitors
frequency range. Depending on the performance and size
of the main monitors the used threshold frequency
between main monitors an sub, may vary from 80 to 120 Hz.
From psycho-acoustics we know that there is no
directional information in audio signals below
approximately 120 Hz. Hence the advantage of placing
the subwoofer in a position where the best distribution is
achieved.
The LFE Channel
LFE is short for Low Frequency Enhancement or Low
Frequency Effects, the first being the original name but
the second being the most correct with regards to its
application.
It is also referred to as the “.1”-channel, which indicates
that the frequency range of this channel is only a fraction
of the other channels in a multi-channel setup. The
actual frequency range is 20 Hz to 120 Hz.
SETUP PAGE
20