TC Electronic G-System, Руководство пользователя

Страница: 62 / 81

FeedB – FeedBack
Range: -100 to 100
This parameter controls the amount of feedback
(Resonance) of the short modulated delay that causes
the Flanging effect. When the Feedback is set too high
(above approximately 90% to 95%), this might introduce
internal feedback, resulting in a squealing noise that in
most cases is unwanted in flanging effects. Be aware of
this side-effect when experimenting at high volumes.
Negative values inverse the phase of the signal that is
fed back to the algorithm’s Input.
FB Cut – Feedback hi-cut
Range: 20Hz to 20kHz
A parameter that can attenuate the high-end frequencies
of the resonance created with the Feedback parameter.
Mix
Range: 0 to 100%
This parameter sets the relationship between the dry
signal and the level of the effect in this Effect Block.
OutLev – Out Level
Range: -100 to 0dB
This parameter sets the overall Output level of this effect.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
Advanced Flanger
Additional parameters to the Classic Flanger:
Fla Dl – Flanger Delay
Range: 0 to 50ms
Typically, Delay values around 5ms are used for Flanging
effects, whereas Chorus effects occur with Delay times
around 10ms. You are free, however, to choose Delay
times from 0 to 50ms.
PhaRev – Phase Reverse
Range: Off/On
Setting this parameter to On reverses the phase of the
processed signal in the right channel. This gives a very
wide Flange effects and a less defined sound.
Ratio – Golden Ratio
Range: Off/On
TC research has shown that when the
speed of a
modulation effect is increased, its depth should be
decreased accordingly to achieve the same amount of
perceived modulation. When the Golden Ratio parameter
is set to On, this value is automatically calculated.
Golden Ratio is a feature inherited from the classic TC
2290 processor.
EFFECTS – MOD
60