TBB power MPPT, Руководство пользователя, Страница: 26 / 36

MPPT charge controller User Manual
2
5
5
.
.
5
5
P
P
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
s
s
e
e
t
t
t
t
i
i
n
n
g
g
i
i
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
Begin
Press the , the cursor appears on
the right side bit of the parameter.
Press the to Change the bit of parameter
Press the , the corresponding bit flashes,
press the to change the value
Adjust the bit, press the , then adjust
the other numbers
Press the and a save prompt appears.
Setting
completed?
Save?
Save
Successful
setting?
Successful setting prompt appears.
The parameter does not change,
returns to the original display, and
return to the begin and set again.
A failure Setting prompt appears.
Go to the next setting item
Yes
No
Change the
parameters?
Yes
No
Press the , a confirmation prompt
appears, press the to set the
default parameter, press to the
begin and set again.
Yes
No
No
Yes
Note: To enter the interface, a password is required. The initial password is "1000", and the user
can modify the password according to the requirements. After logging in the interface, users can
configure system parameters according to requirements.
Detailed description is shown in the following table.
>Parameter Set
>Para_System
Display Setting range Description
SYS_Module_Addr
1~4
；
Default setting:1
Modul parallal address in
system.
>Para_System
Para_Mode
>Para_Battery
Change Password
>Setup Wizard
Reset Parameter