TBB power MPPT, Руководство пользователя, Страница: 22 / 36

MPPT charge controller User Manual
1
4. Configuration
4.1 Check Before Operation
Please check before Operation according to the following.

Solar Mate MPPT charge controller is installed correctly and steady.

Reasonable cable layout to meet customer requirements.

Make sure the grounding is reliable.

Make sure the ground wire is properly connected and firm and reliable.

Double check the battery breaker and PV array breaker is OFF.

Make sure the cables are properly connected and firm and reliable.

Reasonable installation space, clean and tidy environment, no construction residue.
4.2 Power ON Test
Make sure the battery voltage and PV array voltage are within the permissible range
before breaker turn ON.
Please step by step as following instructions.

Step 1: Turn on the circuit breaker between the PV array and the MPPT charger.

Step 2: Turn on the circuit breaker between the battery and the MPPT charger.

Step 3: Set the parameters step by step according to the setup wizard.

Step 4: Observe the LED light to make sure the MPPT charger is running normally. (refer
to Table 2-2 LED directive function)
4.3 Power OFF
After the MPPT charger is power OFF, there is still residual power and heat in the
chassis, which may lead to electric shock or burn. Therefore, after the MPPT charger is
powered off for 5 minutes, you should wear protective gloves before removed the MPPT
charger.
Please step by step as following instructions.

Step 1: Turn off the circuit breaker between the PV array and the MPPT charger.

Step 2: Turn off the circuit breaker between the battery and the MPPT charger
4.4 Setup Wizard
Power ON at the first time or after restoring factory settings, the MPPT charger needs to enter the
setup wizard to work normally. The user can also reset the Setup Wizard through the Parameter Set
interface.
The setup wizard list is shown in the flow diagram.
Enter The
Setup Wizard? Battery_Type
0- GEL/OPzV Battery_AH
200AH Time Set
2019-03-10 13:26
Note: If you want to leave the default values unchanged during the setup process, simply press
<Down> to prompt <Confirm?> , and press <Enter>.