29/ 42
2. Put the fan on the corresponding position of the flywheel, apply an appropriate amount of thread fastening glue on the three
GB5789 M6×16 threads, and tighten with t-sleeve -10#, torque standard: 10±1N.m.
Magneto stator
Assembly
Use a torque wrench (or air batch), inner hexagonal gun head
-5# and outer hexagonal sleeve-8# to fix the 3 GB70.1 M6×25 bolts
on the coil, the 3 bolts on the trigger pressure plate and the stator pressure plate. Remove the M6×16 bolts and take off the
magneto stator.
Install
Put the sub-components of the magneto stator on the corresponding position of the right crankcase cover, apply an appropriate
amount of thread glue on the threads of three GB70.1 M6×25 bolts and three M6×16 bolts, and use torque wrench, inner
hexagonal gun head-5# and outer hexagonal sleeve-8#, screw the bolts into the corresponding threaded holes and tighten them.
The torque standard is GB70.1 M6×25 (zinc
) bolts:
10±1N.m, M6×16 bolts: 12±1.5N.m.
Remarks:
①the trigger cannot be installed backwards, and the side with the sensing point faces inward.
②the arc position of the pressure plate should fit as close as possible to the cylinder of the right box. When the bolts are
tightened, be careful not to lift the pressure plate.
Sensing point
