22/ 42
7
151×3 acrylic glue O-ring
1
8
Cg-78h overrunning clutch
1
9
Φ19.4 ×φ27.8×3.6 bushing
1
10
ZT1P58MJ electric starter reduction gear assembly
1
11
ZT1P58MJ electric starter large gear assembly
1
12
M6×10 top pin bolt
2
Tool: t-sleeve-8#. Apply thread glue, fixed
torque: 12±1.5 N.m
13
ZT1P58MJ guide bar pressure plate
1
14
Gb276-6804/p5c3 deep groove ball bearings
1
15
Circlip for non-
standard holes φ 32×1.2
1
16
6.35×5×96 toothed chain
1
17
ZT1P58MJ electric starter reduction gear shaft
1
Electric starter box cover
Assembly
1. Use a t-shaped sleeve -8# to remove the locking bolt of the electric starter box cover, and take out the electric starter box
cover, φ 16×φ30×9 bushing , 15.6×1.9 fluorine rubber
O-ring , and positioning pin.
Inspection
1. Check the electric starter box cover oil seal, 151×3 acrylate rubber O-ring
, φ 16×φ30×9 bushing outer ring, 15.6×1.9 fluorine
rubber O-ring without scratches or damage, and replace if scratched or damaged .
Install
1. Install the positioning pin on the corresponding position of the left box, and place the 151×3 acrylic glue O-ring on the
corresponding position of the electric starter box cover groove.
2. Install the electric starter box cover to the corresponding position, put in 7 m6×22 hexagon flange bolts, pretighten diagonally
from the positioning pin hole, and the fixed torque is 12±1.5 N.m
. Put the φ 16 × φ 30 × 9 bushing with 15.6 × 1.9 fluorine rubber
