35
Model SB25
Controls and Systems
Rinse PCB
______________________________
The rinse PCB functions as the control center of the
Rinse Station.
To replace the rinse PCB, perform the following
steps.
1.
Turn off the main power to the unit.
2.
Disconnect the power adaptor from the main
power jack.
3.
Disconnect the water supply at the quick
connect fitting.
4.
Remove the bottom cover.
5.
Disconnect all four (4) connections from the
rinse PC board.
Figure 52
6.
Remove the four (4) screws holding the PC
board onto the base.
7.
Install the new PC board.
8.
Reassemble the unit.
Rinse Manifold Replacement
______________________________
To replace the rinse manifold, perform the following
steps.
1.
Turn off the main power to the unit.
2.
Disconnect the power adaptor from the main
power jack.
3.
Disconnect the water supply at the quick
connect fitting.
4.
Remove the bottom cover.
5.
Disconnect the tubing from each end of the
water valve manifold.
Figure 53
6.
Remove the three (3) screws which secure the
water valve manifold to the rinse station
bracket.
7.
Remove the three (3) screws which secure the
bracket to the base.
8.
Install the new water valve manifold.
9.
Reconnect the tubing.
10.
Reinstall the bottom cover.
Содержание SB25
