24
Controls and Systems
Model SB25
Step 5
Remove the blender motor screws and remove the
motor. (
Note:
Per torque specifications, the screws
are tightened to 16 inch/pounds.)
Figure 23
Step 6
Remove the wire harness by pulling it through the
access hole. Bending the wire harness against the
connector is necessary in order to pull the harness
out.
Do not cut the wires.
Ice Chute & Splash Guard
______________________________
Splash Guard
To Install:
Hold the splash guard at a slight angle
and lift the splash guard up and forward, locking the
hooks of the splash guard onto the posts on the ice
chute.
Figure 24
To Remove:
Holding the splash guard at a slight
angle, lift up and pull out and away from the ice
chute to disengage the hooks from the ice chute.
Figure 25
Ice Chute
To Remove:
Squeeze the tabs on the ice chute and
gently pull down on the chute to disengage.
Figure 26
To Install:
Lift the ice chute up into place in the
main drain. Be sure both tabs are locked securely
into place by gently pulling down on the ice chute.
Figure 27
Содержание SB25
