Taylor C707, Руководство оператора

Страница: 11 / 44

Section 3
3-1
Model C707
Safety
3
Safety
We at Taylor Company are concerned about the safety of
the operator when he or she comes in contact with the
freezer and its parts. Taylor has gone to extreme efforts
to design and manufacture built-in safety features to
protect both the operator and the service technician. As
an example, warning labels have been attached to the
freezer to further point out safety precautions to the
operator.
DANGER! Failure to adhere to the following
safety precautions may result in severe personal injury or
death. Failure to comply with these warnings may also
damage the machine and/or its components. Such
damage may require component replacement and
service repair expenses
.
NOTICE! DO NOT operate the machine
without reading the Operator’s Manual. Failure to
follow this instruction may result in machine
damage, poor machine performance, health hazards,
or personal injury.
IMPORTANT! This machine is to be used only
by trained personnel. It is not intended for use by children
or people with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless
given supervision or instruction concerning the use of the
machine by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the machine.
IMPORTANT! This machine is provided with
an equipotential grounding lug that is to be properly
attached to the rear of the frame by the authorized
installer. The installation location is marked by the
equipotential bonding symbol (5021 of IEC 60417-1) on
the removable panel and the frame.
WARNING! DO NOT use a water jet to clean
or rinse the machine. Failure to follow these instructions
may result in serious electrical shock.
WARNING! Avoid injury.
• DO NOT operate the machine unless it is prop-
erly grounded.
• DO NOT operate machine with fuses larger than
specified on the data label.
• All repairs must be performed by a Taylor ser-
vice technician.
• The main power supplies to the machine must
be disconnected prior to performing repairs.
• For Cord-Connected Machines : Only Taylor ser-
vice technicians or licensed electricians may
install a plug or replacement cord on the
machine.
• Stationary machine that are not equipped with a
power cord and a plug or another device to dis-
connect the machine from the power source
must have an all-pole disconnecting device with
a contact gap of at least 0.125 in. (3 mm) in the
external installation.
• Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have devices to protect
against the leakage of current, such as a GFI,
installed by authorized personnel to local codes.
• Supply cords used with this machine shall be

oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other equiva-
lent synthetic elastomer-sheathed cord (code
designation 60245 IEC 57) installed with the
proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors
from abrasion.