Taylor C707, Руководство оператора

Страница: 21 / 44

Section 6
6-1
Model C707
Operating Procedures
6
Operating Procedures
The C707 machine stores mix in a hopper. It has a 3.4 qt.
(3.2 L) freezing cylinder and a 20 qt. (18.9 L) mix hopper.
This machine uses a feed tube to allow mix to flow into
the freezing cylinder.
We begin our instructions at the point where we enter the
store in the morning and find the parts disassembled and
laid out to air-dry from the previous night’s cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them, and
prime the freezer with fresh mix in preparation to serve
your first portion.
If you are disassembling the machine for the first time or
need information to get to this point in the instructions,
turn to Disassembly on page 6-9.
Assembly
WARNING! Make sure the power switch is in
the Off position before installing or removing any parts.
Failure to follow this instruction may result in severe
personal injury or electrocution.
Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
1. Install the driveshaft : Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater driveshaft. Slide the seal over the shaft and
groove until it snaps into place.
Do not lubricate the
hex end of the driveshaft.
2. Fill the inside portion of the seal with 1/4 in. more
lubricant and lubricate the flat side of the seal that fits
onto the rear shell bearing.
Figure 6-1
3. Insert the driveshaft into the freezing cylinder, hex
end first, and into the rear shell bearing until the seal
fits securely over the rear shell bearing. Engage the
hex end firmly into the drive coupling. Be sure the
driveshaft fits into the drive coupling without binding.
Figure 6-2
WARNING! Use extreme caution when
handling the beater assembly. The scraper blades are
very sharp and may cause injury.
11269
Apply the appropriate
Taylor approved food safe lubricant.
11270