Taylor C303, Руководство оператора

Страница: 30 / 53

6-2
OPERATING PROCEDURES
Model C303 & C314
Operating Procedures
6
Figure 6-2
Note: The drive shaft bushing must be positioned in
the center of the drive shaft seal.
2. Lubricate the inside diameter of the drive shaft seal.
Install the drive shaft seal bushing in the drive shaft
seal.
Figure 6-3
Note: The drive shaft bushing must be positioned in the
center of the drive shaft seal.
3. Slide the seal and bushing over the shaft until it
snaps into place.
Figure 6-4
4. Fill the inside portion of the seal with 1/4" more
lubricant and evenly lubricate the end of the seal that
fits onto the rear shell bearing.
5. Insert the beater drive shaft into the freezing cylinder,
slotted end first, and into the rear shell bearing until
the seal fits securely over the rear shell bearing. Be
certain the drive shaft fits into the motor shaft without
binding.
Important! Remove any excess lubricant from the seal.
Figure 6-5
6. Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear. If any
nicks are present or if the blade is worn, replace both
blades. If the blades are in good condition, place the
scraper blades over the holding pins on the beater.
Note: Each hole on the scraper blade must fit securely
over each pin.
Figure 6-6