6-8
OPERATING PROCEDURES
Model 104
Operating Procedures
6
4. Put the control switch into the off position.
5. Hold a pail beneath the ejection port, open the draw
arm, and drain all the solution from the freezing
cylinder.
6. Close the draw arm.
Disassembly
WARNING!
Make sure the power switch is in
the off position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Remove the handscrews from the front of the freezer
door.
2. Remove the pivot pin from the hinge on the freezer
door. Remove the freezer door, beater assembly,
scraper blades, and driveshaft from the freezing
cylinder.
3. Remove the funnel from the top of the freezer and
the rear drip pan from the front panel.
Note:
If the drip pan is filled with an excessive
amount of mix, the seal was installed incorrectly on
the beater assembly or should be replaced.
Brush-Cleaning
1. Prepare a sink with an approved cleaning solution
(for example, Stera-Sheen
®
).
Use warm water and follow the manufacturer’s
specifications.
If an approved cleaner other than Stera-Sheen
®
or
Kay-5
®
is used, dilute the cleaner according to label
instructions.
Important!
Follow label directions. Too
strong
of a
solution can cause parts damage, while too
mild
of a
solution will not provide adequate cleaning. Make
sure all brushes provided with the freezer are
available for brush-cleaning.
2. Remove the seal from the driveshaft.
3. From the freezer door:
• Remove the clevis pin from the stem cap.
• Unscrew the stem cap from the stem.
• Pull the draw arm from the stem.
• Remove the O-ring from the draw plate.
• Remove the O-ring from the back of the freezer
door.
• Remove the drip spout and take the parts to the
sink for cleaning.
4. Thoroughly brush-clean all disassembled parts in the
cleaning solution.
5. Make sure all lubricant and mix film is removed.
Place the cleaned parts on a clean dry surface to
air-dry.
6. Return to the freezer with a small amount of cleaning
solution. With the black bristle brush, brush-clean the
rear shell bearing at the back of the freezing cylinder.
Figure 6-29
7. Wipe clean all exterior surfaces of the freezer.
10143
Содержание 104
