Taylor-Dunn SS-025-34, Руководство по обслуживанию и запасным частям

Страница: 48 / 134

Drive Axle
Page 48
SS and MX Models, DC System
MS-534-13
DRIVE MOTOR
Remove
Note: In some vehicle configurations the
transmission assembly will have to be
removed to allow clearance to remove the
motor. Refer to Transmission section for
information on removing the transmission
assembly from the vehicle.
1: Remove the motor wires from the motor.
2: Remove the bolts holding the motor to the
transmission housing (see illustration).
3: Slide the motor off of the transmission input shaft.
Install
1: Remove the rubber bushing from inside of the
motor armature coupler (see illustration).
2: Thoroughly clean all grease from the
transmission input shaft, rubber bushing and the
motor armature coupling.
3: Install the rubber bushing back into the motor
armature coupling.
4: Lightly grease the transmission input shaft only
(see caution).
5: Install the motor in reverse order.
• Tighten the motor mounting bolts per torque listed
in the Hardware Torque table at the end of this
section.
• Tighten the motor terminals per torque listed in the
Hardware Torque table at the end of this section.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
Do not apply grease to the armature coupler,
rubber bushing or the end of the transmission input
shaft. Grease applied to these areas may result in
premature failure of the armature bearing.