Taylor-Dunn SS-025-34, Руководство по обслуживанию и запасным частям

Страница: 40 / 134

Steering
Page 40
SS and MX Models, DC System
MS-534-13
REPLACE STEERING WHEEL
Note: The steering wheel is on a tapered shaft and
may be damaged when it is removed.
1: If equipped with a horn switch in the steering
wheel, remove the switch and disconnect the
wires from the switch.
2: Remove the steering wheel nut.
3: Using a steering wheel puller, remove the
steering wheel.
4: Position the front wheels in the straight ahead
position.
5: Lightly grease the steering wheel splines and
install the replacement steering wheel orientated
as shown in the illustration.
6: Tighten the steering wheel nut to torque listed
in the Hardware Torque table at the end of this
section.
7: Reconnect the main positive and negative cables
at the batteries.
8: Remove the blocks from behind the wheels.
9: Release the parking brake and test drive.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
REPLACE STEERING TILLER
1: Remove the headlight.
2: Remove the tiller pinch bolt holding it to the fork
spindle.
3: Drive a large slotted screwdriver or chisel
between the pinch bolt collar tabs to spread them
apart and remove the tiller from the fork spindle.
4: Thoroughly clean the fork spindle.
5: Confirm the woodruff key is properly installed in
the spindle.
6: Align the slot in the tiller with the woodruff key
and push the tiller down onto the spindle making
sure that the key stays in place.
7: Install the tiller pinch bolt and nut. Tighten per
torque specifications at the end of this chapter.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING