Taylor-Dunn Bigfoot G-1500, Руководство по обслуживанию и запасным частям

Страница: 52 / 118

CVT
Page 52
Bigfoot G-1500
MB-440-10
DRIVE BELT
Note: The ramp shoes should be inspected any time
the belt is serviced.
Remove
1: Turn engine off and allow the exhaust system to cool.
2: Disconnect the battery negative lead.
3: Place the transmission in neutral.
4: Grab the drive belt and pull up until you can move
it over the side of the driven pulley as show in the
illustration.
5: Keeping fingers clear of the drive belt, rotate the
pulley until the belt comes off.
Inspect
Measure the width of the belt in at least 4 points along the
length. If any one point is less than 1.031 inch (26.2 cm) then
the belt should be replaced.
Run your fingers along both sides of the belt. If you can feel
any low sections then the belt should be replaced.
Install
6: Disconnect the battery negative lead.
7: Place the transmission in neutral.
8: Wrap the belt around the driver pulley.
9: Starting at the bottom of the driven pulley, start
wrapping the belt around the pulley. When it gets
difficult to continue, finish by rotating the pulley until
the belt is fully seated.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter and beginning of this
section..
WARNING