tayco Kip, Руководство по установке

Страница: 10 / 25

Kip community table – 1 Surface
Figure 8
Tools & Hardware Needed
8540-0789_SCREW 8540-1280
Drill Robertson # 2 Hex Bit #10 X 1" Pan Head
Screw (1X) 1/4-20 X 35MM JCB
Bolt (2X)
21.
Screw 1/4-20 X 35mm JCB bolts
into the two holes at the corner
of the bridge exposing an inch
of the bolt, (Figure 8).
22.
Set-in the topmost hole of the
gable cover mount channel
using one #10 X 1” Pan Head
Screw into the pre-drilled hole.
Note: Do not tighten the screw
so you can easily swing the
gable cover mount channel,
(Figure 8).
23.
Swing the gable cover mount
channel until the slots touch
the JCB bolts, (Figure 8).
Continued on the next page >>
FEBRUARY 2020 kip 7