Task Force 227684, Инструкция по эксплуатации

Страница: 16 / 19

TROUBLESHOOTING
Trouble Possible Cause(s) Corrective Action
Handle not in position.
•
Carriage bolts.
•
Adjust the height of the handle
and make sure that the carriage
bolts are seated properly.
•
Tighten hand knobs.
Mower not starting.
•
Cord disconnected from the
motor control.
•
Motor control switch defective.
•
Extension cord not connected
to the mower plug.
•
Extension cord not connected
to power source.
•
Tripped circuit breaker in the
house.
•
Reconnect the cord and using
the cord restraint keep the cord
close to the motor/blade control.
•
Replace motor control switch.
•
Connect the extension cord to
the plug on the mower.
•
Connect the extension cord to a
live 120 V AC 60 Hz AC
receptacle.
•
Reset the house circuit breaker.
If it trips again call a qualified
electrician.
Mower cutting
grass
unevenly.
•
Lawn is rough or uneven. Cutting
height not set properly.
•
Move the wheels to a higher
position.
•
All wheels must be placed in the
same cutting height for the
mower to cut evenly.
Mower not mulching
properly.
•
Wet grass clippings stick to the
underside of the deck.
•
Wait until the grass dries before
mowing.
Hard to push.
•
High grass or cutting height too
low.
•
Rear of mower housing and
blade dragging in heavy grass.
•
Raise cutting height.
Mower vibrating at
higher speed.
•
Bent motor shaft.
•
Blade is unbalanced.
•
Stop the motor, disconnect the
power source and inspect for
damage.
•
Repair before restarting. If
vibration persists, take it to a
service dealer.
•
Balance the blade by grinding
each cutting edge equally.
16