DS-D98 recorder
TASCAM DS-D98 -
5
Rear panel connections
NOTE
All items not mentioned here are explained in the main
DA-98HR manual. Consult 2.2, “Rear Panel connectors”
for full details.
1
SYNC BRANCH OUT
Connect this to the
REMOTE IN/SYNC IN
of a branched DTRS unit
using a PW-88S cable. See “SYNC BRANCH func-
tions” on page 10 for details.
2
SDIF-3 IN
This pair of BNC connectors is
used for inputting DSD data (each connector carries
one channel).
Connect these inputs to suitably-equipped DSD
devices, and select the format using the menu item
(“DSD Digital I/O” on page 7).
3
SDIF-3 OUT
This pair of BNC connectors is
used for outputting DSD data (each connector carries
one channel).
The exact signals being monitored depend on the
transport status and the status of the
INPUT
MONITOR
of the tracks as well as the confidence
mode. See 5, “Monitoring modes” of the DA-98HR
manual for full details of monitoring modes.
Connect these outputs to suitably-equipped DSD
devices, and select the format using the menu item
(“DSD Digital I/O” on page 7).
4
MONITOR OUT (AES/EBU) 44.1kHz
This XLR-type connector outputs AES/EBU data at
44.1kHz for the purposes of monitoring. Connect
this to a suitably-equipped device to allow monitor-
ing of the recordings made on the DS-D98
5
AUX
This 9-pin D-sub connector is reserved
for future expansion, providing remote control of the
REC FUNCTION
, as well as AES/EBU outputs.
6
ANALOG INPUTS (1, 2)
This pair of bal-
anced XLR-type connectors is used for the input of
analog audio.
7
ANALOG OUTPUTS (1, 2)
This pair of
balanced XLR-type connectors is used for the output
of analog audio.
2
5
4
3
1
6
7
